B&K Precision 866C Manual de usuario descargar pdf (Pagina 39)

Keys Display

2.5 Enter SHORT OFF We select short on and then press Enter.

Enter▽ READBACK A We want to readback the current, so we press Enter.

Enter MIN 2= 4.950A Our minimum value is 2.0 A.

2 Enter MAX 2= 5.050A We choose 2.5 A as the maximum value.

2.5 Enter DELAY 2= 3.0<S> We'll wait 2 seconds for the maximum current.

2 Enter STORE TEST FILE1 The 1 is underlined, meaning you can choose

which test file number to store this test to. You can choose any number

between 1-8. Here, we will use 1, so just press Enter.

Enter EDIT TEST FILE

Esc Esc Exit the menu. The normal display is shown (V and A).

The test file has been created and saved in file position 1. Now we will run the test on the device.

Keys Display

Shift + Menu :CONFIG

▽ ▽ :LIST SET

Enter :MODE SET

▽ ▽ ▽ :CALL TEST FILE

Enter RECALL 1 We're being prompted for which file number to recall. Since

we saved to file number 1, we just press Enter.

Enter CALL TEST FILE The test file is now loaded, so we return to the normal

display.

Esc Esc Exit the menu. The normal display is show (V and A).

Shift I-set NAME:TEST FILE 1 We've entered automatic testing mode. The display

is showing which test file we're using.

Shift Trigger This starts the test. You'll see the values sequentially displayed. Then

you'll either see PASS or FAULT. You can press Shift Trigger again for

another test run or press Esc to return to the normal display.

Esc Return to the normal display.

Triggering

Triggering is used with the transient and dynamic conditions to allow synchronization of the DC

Load's behavior with other events. There are three types of triggers you may use (set in the

CONFIG:TRIGGER SOURCE menu):

Trigger Type Explanation

IMMEDIATE An immediate trigger is created by pressing Shift + Trigger on the

8500 DC Load Series Version: November 4, 2008 Page 39 of 76

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 75 76

Sin comentarios

B&K Precision 866C Manual de usuario Pagina 39